Installation Instructions Bifold Closet Doors Hardware

Wardrobe Bifold Closet Doors Hardware

Bifold closet doors hardware – Let’s starting with head width of the cabinet opening. If this opening is larger than 36 inches, two bifold doors. Subtract 1/4 inch from the measurement and divide it by two if you install two doors. Cutting each slot of this length with a hacksaw. Then, mark the center of the top of the cabinet with a pencil. Connecting the two pieces of track with the track link plate. Ensuring these pieces heading cabinet with screws.

Still rotated predrilled holes on top of the conductive panels of bifold doors. Gently tap them with a hammer. Place the guide turned the holes on guiding the doors and press them too. Next ways to installing bifold closet doors hardware, specify the bottom turned into the holes at the bottom of bifold door guides and hammer them in. Seats jamb bracket on the floor directly below the pivot point system bracket. Bor hole pilot in the doorjamb and the floor before securing the jamb bracket with screws.

Best Post :  Practicity and Beauty Everbilt Sliding Door Hardware

Slide rounded guide for the center of the track. Measure from the floor 36 inches. Make a mark at this level in the center of the door. After that, drill holes through the door on the mark you made. Space back of the pull knob behind the door and turn the knob. Last, close the doors and measures 12 inches from the floor. Make a mark on this height on the inside of each door on the inside. Securing a door aligner on every door in this notice. Bifold closet doors hardware installation was finished.